MAINTENANCE
INSPECTION
AND MAINTENANCE SCHEDULE
INSPECTION AND MAINTENANCE SCHEDULE
Routine inspection and maintenance is necessary for all mechanized products. Periodic maintenance
contributes to the product's
life span. The following chart provides guidelines for outboard inspection and
maintenance to be performed by an authorized
Dealer.
The recommended lubricants have been formulated to protect bearings, gears and engine components.
They must be used to avoid damage caused by improper
lubrication.
IMPORTANT: Outboards used for rental operations, commercial applications, or other high hour use
applications require more frequent inspections and maintenance. Inspection and maintenance should be
adjusted according to operating conditions and use; and
environmental conditions.
Engine Maintenance and Inspection Schedule
Frequency
1/1
1/1
1/1
..
..
..
:::l
:::l
:::l
0
0>-
01/1
l:>-
l:=
I:
l:-'=
0=
CU
Q)
0
-
O:::l
1/1
...
-
01:
OCU
01:
~
:::l-
InO
...
:::l
NI:
Engine
0(.)
~E
>-1:
~.!!!
-'=
l:~
..
I:
Care
(.)
'1/1
Q)CD Q)<C
Q)CD
Description
Product
cu
01:
>
..
>
..
>
..
w
...
-
wo wo
wo
Clamp screws, lubricate (lJ
0 Every 60 days / Every 30
in
Saltwater
Tilt/run lever
shaft / tilt shaft, lubricate (l J
0 Every 60 days / Every 30 in Saltwater
Swivel
br~9ket
/ tilt support bracket,
0 Every 60 days / Every 30 in Saltwater
lubricate
1
Shift lever
Sh~~
and detent / shallow water drive bracket, inspect
0
Every 60 days / Every 30 in Saltwater
and lubricate 1
Engine cover latch, lubricate \
1)
0
Every 60 days / Every 30 in Saltwater
Throttle
and shift linkage, lubricate (lJ
0
Every 60 days / Every 30 in Saltwater
R~oke,
carburetor linkage / starter lockout, inspect and lubricate
0 Every 60 days / Every 30
in
Saltwater
Fish line trap, inspect
Every
60 days / Every 30 in Saltwater
Anticorrosion anodes, check operation
./ ./
Water intake screens, check condition
./ ./
Overboard water pump indicator, check operation
./
./
Steering friction, check operation
./
./
Steering system, check operation
./
./
Throttle and shift operation, check function
./
./
Emergency stop circuit and lanyard, check function
./
./
Flush cooling system
./
Emergency start cord, onboard and inspect
./
Operator's Guide, onboard
./
Clamp screws, tighten
./
Engine upper and lower motor covers, clean and wax
./
Operator's Guide, review
./
Fuel filter inspection, eliminate contamination
./
Fuel system components, inspect and repair leaks
\~)
./ ./
Fastener inspection, tighten loosened components
./ ./
Engine to transom mounting hardware, re-torque
./
./
58
To Next Page
Loading...
Need help?
General
