Rev. 2.0
Maintenance Guide
1-30
1-5. Replacing the Cableveyor
1-5-1. Replacing the X-Axis Cableveyor
<M and L board specifications> X_CABLE_BEAR (Part No.: 40110451)
1) Remove the hexagon socket head cap bolt (M4×10) to detach the X_CABLE_BEAR from
the HEAD_PLASTIC_RAIL_BR and X_CB_SUPPORT.
2) Remove the M5 nut and washer assembled hexagon socket head cap bolt (M5×14) to
detach the M5 flat washer, FC_SUPPORT, and FC_RUBBER.
3) Remove the round screw (M5×10) to detach the FC_SUPPORT_X and FC_RUBBER.
4) Remove the arm of the X-axis cableveyor, take out the cables, and replace the cableveyor.
5) Reassemble the components in the reverse order of disassembly. At this time, pay special
attention
so that the cables inside the cableveyor are not entangled.
Additionally, push the cables inside the X-cableveyor by hand to check that they are flexible.
M5 nut
M5 flat washer
HEAD_PLASTIC_RAIL_BR (40071578)
FC_SUPPORT (L153E221000)
FC_RUBBER (L153E321000)
Washer assembled hexagon socket head cap bolt (M5 × 14)
Hexagon socket head cap bolt (M4
10)
Round screw (M5 × 10)
FC_SUPPORT_X (40093858)
FC_RUBBER (L153E321000)
X_CB_SUPPORT (40110212)
X_CABLE_BEAR (40110451)
A
B
Part A
Part B
Arm
Figure 1-5-1-1 X-Axis Cableveyor (M and L Board Specifications)
To Next Page
Loading...
Need help?
General
