Juniper CTP Series User Manual

To configure signaling for CTP bundles using CTPView:
1. In the side pane, select Bundle > Configuration.
2. Run your mouse over the Display and Select an Existing Bundle bar.
3. In the table of bundles, select the bundle that you want to modify.
4. Under Bundle Options, select Advanced Options Show to display advanced
parameters and configure the parameters as described in Table 19 on page 45.
5. Click Click to Submit Bundle AND Port Changes.
Table 19: CTP Bundle Signaling Settings in CTPView
Your ActionFunctionField
Select the number of packets:
•
0
•
1
•
2
•
3
Specifies the output signaling delay in
packets.
Signal Out -
Output Delay
Select one:
•
Fixed - ON/0/Space/Low—Signal is turned on.
•
Fixed - OFF/1/Mark/High—Signal is turned off.
•
InBand - From Remote RL—Output signal is based on the state
of the RL input signal from the DCE or the TM signal from the
DTE.
•
InBand - From Remote RTS—Output signal is based on the state
of the RTS input signal from the DCE or the CTS signal from the
DTE.
•
InBand - From Remote DTR—Output signal is based on the state
of the DTR input signal from the DCE or the DSR signal from the
DTE.
•
InBand - From Remote LL—Output signal is based on the state
of the LL input signal from the DCE or the DCD signal from the
DTE.
Specifies the output signal depending
on whether the bundle is configured as
the DCE or the DTE:
•
DCE—DSR output signal.
•
DTE—DTR output signal.
Signal Out -
DSR/DTR
45Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English