Juniper CTP Series User Manual

3. Select a bundle from the list.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
4. Select 3) Port Config.
5. Select 2) Interface.
6. Set Mode to DCE and set Encoding to TRANS.
7. Follow the onscreen instructions to configure the options as described in
Table 24 on page 61.
Table 24: Transparent Mode Parameter Settings in the CTP Menu
Your ActionFunctionField
Enter a number from
0.00100 through
1024.000000 KHz.
Specifies the speed of the port. For transparent mode circuits, the port
speed is the sample rate for user data. Therefore, the port rate should be
a multiple of the user data rate. In networks without bandwidth constraints,
we recommend a multiple of 10.
Enter Synthesized port
rate (KHz)
Specify y (yes) or n (no).Specifies whether adaptive clocking is enabled for this circuit.
If both end nodes are not locked to a clock reference, we recommend that
you enable one end (not both) for adaptive clocking
Enable adaptive
clocking?
Specify y (yes) or n (no).If you enabled adaptive clocking, specifies whether or not to initialize
adaptive clocking parameters to their default values, which depend on
port speed, packet size, and buffering parameters set on the bundle.
We recommend the following settings:
•
If you are configuring the bundle for adaptive clocking for the first time,
enter y.
•
If you have previously configured the bundle to optimize adaptive
clocking for this network, enter n.
Initialize adaptive
clocking parameters?
y[n]: y
Specify y (yes) or n (no).Enables or disables the phase-correction FIFO buffer. This FIFO buffer
aligns the clock and data phase relationship on a TRANS encoded circuit
in which the clock travels in one direction and the data travels in the
opposite direction.
Enable this FIFO buffer at one end of the circuit, but not at both ends.
Enable 16 bit FIFO?
Specify y (yes) or n (no).Specifies whether or not to invert the FIFO write clock.Invert FIFO Write clock?
Specify y (yes) or n (no).Specifies whether or not to invert the FIFO read clock.Invert FIFO Read clock?
61Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English