Juniper CTP Series User Manual

Table 37: CTP Bundle 4WTO Port Parameter Settings in CTPView (continued)
Your ActionFunctionField
Select DCE.Specifies that the interface is connected
to a data communication equipment
(DCE) device.
I/F Mode
Select DCARD.Specifies the daughter card as the
interface type.
I/F Type
Select one:
•
Channel 0—Enables only channel 0.
•
Channel 1—Enables only channel 1.
•
Dual Channel—Enables both channel
0 and channel 1.
Specifies the voice channel or channels
to enable on the 4WTO daughter card.
Each CTP port with the daughter card
installed can support either one or two
channels.
Channel Options
Enter a number from 0 through 255.Specifies the output level for the 4WTO
daughter card.
Note the following information about the
values:
•
0—Gain is 2:3 (signal is attenuated
33% or 1.8 dB).
•
25—Unity gain, which means there is
no attenuation or gain.
•
255—Gain is 4:1 (signal is amplified
400% or 6 dB).
Intermediate values are derived with
linear interpolation. The actual gain
depends on the impedance of the
attached device.
Output Level
87Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Configuring CTP Bundles

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English