Powering On the SRX110 Services Gateway
To power on the services gateway:
1. Ensure that you have connected the power supply to the device.
2. Insert the plug of the power supply adapter into an AC power source receptacle.
3. Turn on the power to the services gateway.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights up during startup and remains on steadily when the device is
operating normally.
NOTE: After the power supply is turned on, it can take up to 60 seconds for
status indicators—such as the Status and Power LEDs—to show that the
power supply is functioning normally.
NOTE: We recommendyou issue the CLI command request system power-off
when you want to power off the device immediately after powering it on.
Related
Documentation
Powering Off the SRX110 Services Gateway on page 105•
• Resetting the SRX110 Services Gateway on page 107
• Connecting the SRX110 Services Gateway to the Power Supply on page 101
• Grounding the SRX110 Services Gateway on page 103
• Using the Reset Config Button on the SRX110 Services Gateway on page 145
• SRX110 Services Gateway Front Panel and Back Panel Views with 3G and Integrated
VDSL2 on page 9
• SRX110 Services Gateway LEDs on page 13
Powering Off the SRX110 Services Gateway
You can power off the services gateway in one of two ways:
•
Graceful shutdown — Press and release the Power button. The device begins gracefully
shutting down the operating system and then powers itself off.
•
Forced shutdown — Press the Power button and hold it for more than 10 seconds. The
device immediately powers itself off without shutting down the operating system.
NOTE: Do not press the Power button while the device is shutting down.
105Copyright © 2012, Juniper Networks, Inc.
Chapter 14: Connecting, Grounding, and Powering On the SRX110 Services Gateway
To Next Page
Loading...
Need help?
General
