CHAPTER 16
Establishing Basic Connectivity
•
Connecting the SRX110 Services Gateway to the J-Web Interface on page 113
•
Connecting the Services Gateway to the CLI Locally on page 115
•
Connecting the Modem at the SRX110 Services Gateway End on page 117
•
Connecting the Modem to the Console Port on the SRX110 Services Gateway on page 118
•
Connecting to the CLI at the User End for the SRX110 Services Gateway on page 118
Connecting the SRX110 Services Gateway to the J-Web Interface
If you plan to use the J-Web interface to configure the SRX110 Services Gateway, you
must connect through one of the built-in Ethernet management ports.
When the services gateway is powered on for the first time, the system looks for a Dynamic
Host Configuration Protocol (DHCP) server. If it does not find one, the system assigns
an IP address within the 192.168.1.0/24 subnetwork to any devices connected to the
system.
To connect to the J-Web interface through any of the ports fe-0/0/1 through fe-0/0/7
on the services gateway, see Figure 28 on page 114.
113Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
