}
lo0 {
unit 0 {
family inet {
address 172.16.1.24/32;
}
}
}
}
18. Commit the configuration to activate it on the device.
[edit]
admin@# commit
19. Optionally, configure additional properties by adding the necessary configuration
statements. Then commit the changes to activate them on the device.
[edit]
admin@host# commit
20. When you have finished configuring the device, exit configuration mode.
[edit]
admin@host# exit
admin@host>
NOTE: SRX110B-VA and SRX110B-VB do not support security features such
as unified threat management and intrusion detection and prevention.
Related
Documentation
SRX110 Services Gateway Secure Web Access Overview on page 131•
• SRX110 Services Gateway Software Configuration Overview on page 121
• Performing Initial Software Configuration on the SRX110 Services Gateway Using the
J-Web Interface on page 126
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
J-Web Interface
This topic includes the following sections:
•
Establishing Basic Connectivity on page 126
•
Configuring Basic System Properties on page 128
Establishing Basic Connectivity
To establish basic connectivity:
1. Connect an Ethernet cable from any of the fe-0/0/1 to fe-0/0/7 ports to the Ethernet
port on the management device (workstation or laptop).
2. Connect the power cable to the device and a power source. (We recommend using
a surge protector.) Note the following indications:
Copyright © 2012, Juniper Networks, Inc.126
SRX110 Services Gateway Hardware
To Next Page
Loading...
Need help?
General
