Transmitting - (continued)
6-26
Resending (Restored Transmission)
When memory transmission is selected, documents sent to a remote unit that is busy or other-
wise unavailable will be stored in memory for a fixed period of time, and the Re-Tx icon will be
indicated on the JOB LIST screen. Documents stored in memory can be selected and sent
again to the same remote station or to a different remote station.
•
Restored transmission is only possible when memory transmission is set.
• Transmission documents are not stored in memory when a transmission has been can-
celled by pressing [STOP] during transmission.
• The restored transmission setting of Key Operator mode must be set to ON in order to store
documents that were unable to be sent for a fixed period of time in memory.
The amount of time documents are stored in memory can be selected from four levels of
12, 24, 48 and 72 hours. For detail, see "Setting up retransmission" (p. 14-40).
The restored transmission setting is set to OFF at the time of purchase.
1. Press [FA X] on the control panel to display the FAX Basic
screen.
2. Press [CHECK] on the control panel.
3. Press Re-Tx.
DETAILS
To Next Page
Loading...
Need help?
General
