Konica Minolta 7145 User Manual

12-2
Polled Transmission
Polled transmission enables the FK-102 Type-A to scan a document and store it in memory until
a remote station sends a polling command, which causes transmission of the stored document.
Polled transmission provides two options: One option uses Memory that is exclusively designated
for storing polled transmission documents; the other option uses the Bulletin board for the same
purpose. The description below assumes use of the former option, which uses exclusive mem-
ory. To use the Bulletin board option, see "Bulletin" (p. 12-6).
>>> Specifications for Polled Tx <<<
• Only one document can be transmitted by Polled transmission.
• The Memory Tx is automatically selected.
Functions incompatible with Polled Tx
Total page set, Polling Rx, Timer Tx, Int'l com, ECM off, Confiden. Tx, ID Tx, Bulletin,
Relay Tx Req, V34 OFF
• Unavailable with the Internet Fax.
Perform the following procedure to use Polled Tx.
1. Press [FA X] on the control panel to view the FAX Basic
screen, if it is not already displayed.
2. Press APPLICATION on the FAX Basic screen.
3. Press Polled Tx.
Polled Tx becomes reversed.
4. Press OK.
The FAX Basic screen will be restored.
To release the setting, press CANCEL.
5. Set other functions if necessary.
See "Setting Transmission Conditions" (p. 6-10) for information about setting functions in the
Fax Basic screen. See "Application Functions Overview" (p. 10-5) for information about set-
ting functions in the Fax Application Menu.
DETAILS
HINT
FAX

Konica Minolta 7145 Specifications

General

Brand	Konica Minolta
Model	7145
Category	Copier
Language	English