10-30
ECM Off
Transmission can be made with ECM disabled. Error Correction Mode (ECM) is a mode of trans-
mission with error correction established by ITU-T (International Telecommunications Union).
FAX machines equipped with the ECM feature can communicate with each other and can confirm
that the data sent is free of errors. Thus, communication can be made free from disturbances
due to line noises, etc. The FK-102 Type-A employs ECM for transmission unless you disable it.
>>> Specifications for ECM off <<<
• If there are many line disturbances, the communication time may be a little bit longer
with ECM enabled than with ECM disabled.
• ECM will be resumed automatically on completion of transmission.
Functions incompatible with ECM off
Polling Rx, Polled Tx, V34 OFF, Bulletin, Polling Rx
• Unavailable with the Internet Fax.
1. Press [FA X] on the control panel to view the FAX Basic
screen, if it is not already displayed.
2. Press APPLICATION on the FAX Basic screen.
3. Press .
4. Press ECM off.
To exit, press CANCEL or press ECM off again.
5. Press OK.
The FAX Basic screen will be restored.
6. Set other functions if necessary.
See "Setting Transmission Conditions" (p. 6-10) for information about setting functions in the
Fax Basic screen. See "Application Functions Overview" (p. 10-5) for information about set-
ting functions in the Fax Application Menu.
7. Designate the remote station.
See "Selecting a Remote Station" (p. 6-14) for information about designating the remote sta-
tion.
DETAILS
HINT
HINT
FAX
To Next Page
Loading...
