bizhub 501/421/361 (Version 2) 9-19
Replacing toner cartridges and staple cartridges and emptying punch scrap box
9
9.3 Emptying punch scrap boxes
Even when the punch scrap box of the Finisher FS-523 is full, the message is not displayed. Before using
punch mode, perform the following procedure to check if the punch scrap box, if needed. To empty the
punch scrap box, see "To empty the punch scrap box of FS-523" on page 9-20.
When the punch scrap box of the Punch unit PU-501 mounted on the Finisher FS-522, the following message
will be displayed on the screen, and the finished set will be output without being punched. To empty the
punch scrap box, see "To empty the punch scrap box of PU-501" on page 9-22.
Screen when a Punch setting is selected
Screen while a job is being performed
To Next Page
Loading...
Need help?
General
