Kubota L2800 Workshop Manual

8-M2
L2800, L3400, WSM
HYDRAULIC SYSTEM
2. HYDRAULIC CYLINDER
The main components of the hydraulic cylinder are shown in the figure above.
While the lift arm (11) is rising, oil from the hydraulic pump flows into the hydraulic cylinder (4) through the position
control valve (14). Then oil pushes the hydraulic piston (7) out.
While the lift arm (11) is lowering, oil in the hydraulic cylinder (4) is discharged to the transmission case through
the position control valve (14) by the weight of the implement. At this time, the lowering speed of the implement can
be controlled by the lowering speed adjusting valve (3) attached to the hydraulic cylinder (4). Turning the lowering
speed adjusting knob (1) clockwise decreases the lowering speed, and counterclockwise increases lowering speed.
When the lowering speed adjusting valve (3) is completely closed, the lift arm (11) is held at its position since oil in the
hydraulic cylinder (4) is sealed between the hydraulic piston (7) and the position control valve (14).
(1) Lowering Speed Adjusting
Knob
(2) Lowering Speed Adjusting
Shaft
(3) Lowering Speed Adjusting
Valve
(4) Hydraulic Cylinder
(5) O-ring
(6) Back-up Ring
(7) Hydraulic Piston
(8) Hydraulic Rod
(9) Hydraulic Arm
(10) Hydraulic Arm Shaft
(11) Lift Arm
(12) Position Control Arm
(13) Spool Drive Lever
(14) Position Control Valve
KiSC issued 08, 2007 A
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland

Kubota L2800 Specifications

General

Engine Type	Diesel
Engine Power	28 hp
Type	Compact utility tractor
Rear tire size	11.2-24
PTO Horsepower	23.5 hp
Weight	2, 425 lbs
Drive	4WD
Front tire size	5.00-15 (2WD)