G-55
L2800, L3400, WSM
G GENERAL
9. TIRES
[1] TIRE PRESSURE
Though the tire pressure is factory-set to the prescribed level, it
naturally drops slowly in the course of time. Thus, check it everyday
and inflate as necessary. To inflate the wheel tires, use an air
compressor or hand pump.
• Recommended inflation pressure
Maintain the pressure shown below.
CAUTION
• Do not attempt to mount a tire. This should be done by a
qualified person with the proper equipment.
Qualified person with the proper tire mounting equipment
should recognize the following warning.
• Never exceed 241 kPa (2.5 kgf/cm
2
, 35 psi) when attempting
to seat a bead. If beads have not been seated by the time the
pressure reached 241 kPa (2.5 kgf/cm
2
, 35 psi), deflate the
assembly, reposition the tire on the rim, relubricate and
reinflate. After seating the bead, adjust inflation pressure as
recommended in the inflation pressure chart.
W10440050
Tire sizes Inflation Pressure
Rear
11.2-24, 4PR 100 kPa (1.0 kgf/cm
2
, 14 psi)
13.6-16, 4PR 100 kPa (1.0 kgf/cm
2
, 14 psi)
15-19.5, 6PR 210 kPa (2.1 kgf/cm
2
, 30 psi)
Front
5.00-15, 4PR 220 kPa (2.2 kgf/cm
2
, 32 psi)
7-16, 6PR 250 kPa (2.5 kgf/cm
2
, 36 psi)
23 x 8.50-12, 4PR 160 kPa (1.6 kgf/cm
2
, 23 psi)
25 x 8.50-14, 6PR 160 kPa (1.6 kgf/cm
2
, 23 psi)
27 x 8.50-15, 6PR 210 kPa (2.1 kgf/cm
2
, 30 psi)
(1) Ground (A) Insufficient
(B) Standard
(C) Excessive
Tractor Manuals Scotland - Please Do Not Copy
To Next Page
Loading...
Need help?
General
