329
PRO1 Live Audio System
Owner’s Manual
Appendix D: Troubleshooting
This appendix gives details of troubleshooting the PRO1 Live Audio System.
No audio
If you have set up the PRO1 and followed all of the instructions for obtaining audio, but
you are not hearing anything through the speakers, check the following:
• Make sure the appropriate ST buttons in the channel fast strips are on.
• Make sure the appropriate ST buttons in the source a/b panels (monitors section of
the output bay) are on.
• Make sure nothing is muted.
• Make sure no faders are set to minimum.
• Check that the VCA group and master faders are at unity gain.
• Use solo at selected points in the signal path to try and pinpoint where the signal is
being lost.
•Check the Preferences screen for correct signal routing by making sure channel
sources/destinations are correctly assigned.
If you still don’t have any audio, contact Midas Technical Support.
Diagnostics
You can view the Diagnostics screen to get an overview of the current health and
status of the system. The Diagnostics screen shows real-time connectivity of the
system, the health of connected nodes and whether a device is configured or not.
The status LED at the top of the screen, which is constantly displayed while the control
centre is switched on, is linked to the status of individual items on the Diagnostics
screen. If there is a problem, you can click the status LED to open the Diagnostics
screen and see what is causing the error.
To Next Page
Loading...
Need help?
General
