25
PRO1 Live Audio System
Operator Manual
Chapter 4: Setting Up The System
Before installing, setting up or operating this equipment, make sure that
you have read and fully understand all of this section and the “IMPORTANT
SAFETY INSTRUCTIONS” at the front of this manual.
This chapter shows you how to set up an PRO1 Live Audio System to its default
configuration.
Note: If you want to set up the PRO1 Live Audio System using a configuration other
than the default, please contact Midas Technical Support for details.
Initial set-up procedure
Initial system set-up basically comprises:
• Unpacking and checking the equipment — see “Unpacking the equipment”
below.
• Making up the rack — see “Making up a rack” below.
• Installation — see “Installation” below.
• Connecting up the equipment — see “Connecting up” on page 28.
• Powering the equipment — see “Powering the PRO1 system” on page 30.
• Setting up the I/O rack device (initial patching) — see “Configuring the
devices” on page 58.
• Configuring the DL251 Audio System I/O unit — see the DL251/DL252 Audio
System I/O Operator Manual.
Unpacking the equipment
After carefully unpacking the equipment, save all packing materials, as they will prove
useful if you need to transport the equipment later.
Inspect the equipment carefully for any sign of damage incurred during transportation.
It has undergone stringent quality control inspection and tests prior to packing and was
in perfect condition when it left the factory. However, if the equipment shows any signs
of damage, notify the transportation company without delay. Only you, the consignee,
may institute a claim against the carrier for damage during transportation.
Installation
Before installing the equipment:
• Make sure the equipment is correctly connected to the protective earth conductor of
the mains voltage supply of the system installation through the mains leads.
• Power to the equipment must be via a fused spur(s).
• Power plugs must be inserted in socket outlets provided with protective earth
contacts. The electrical supply at the socket outlets must provide appropriate
over-current protection.
• Both the mains supply and the quality of earthing must be adequate for the
equipment.
To Next Page
Loading...
Need help?
General
