Native Instruments Maschine MIKRO User Manual

For more information on the Cue channel, please refer to section ↑9.2.6, Using the Cue
Bus.
If there are more than 16 Slices, you can select which set of 16 Slices should be triggered by
your pads:
►
If there are more than 16 Slices, press SHIFT + Left/Right Arrow button to switch your
pads to the previous/next 16 Slices, respectively.
Note that we haven’t applied any slicing yet: For now your pads only allow you to prelis-
ten how the proposed would sound after you apply the slicing. Applying the slicing will
be described in section ↑14.4.5, Applying the Slicing.
Slicing Parameters
1. To select the parameters described below, press the Left/Right Arrow buttons.
2. To adjust the selected parameter, turn the Control encoder (for continuous parameters,
press and turn the Control encoder to adjust the value in finer increments).
Following parameters are available:
Parameter
Description
TIME Section
MODE Here you can select either SPLIT, GRID, DETECT or MANUAL:
Split mode: The Sample will be sliced into equally spread Slices.
Grid mode: The Sample will be sliced according to note values.
Detect mode: The Sample will be sliced according to its transients.
Manual mode: You can manually slice the Sample as you see fit.
SLICES (Split and
Grid mode only)
When MODE is set to SPLIT (see above), SLICES lets you choose the
amount of Slices: 4, 8, 16 or 32.
When MODE is set to GRID (see above), SLICES lets you choose the
length of the Slices in note values: 4th, 8th,16th or 32nd notes.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE MIKRO - Manual - 794

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English