Inspecting with the Shape Search II Inspection Item
FQ2 User’s Manual
4
Setting Up Inspections
107
Obtaining Multiple Results Simultaneously
You can detect all items that satisfy the extraction conditions.
Judgement is performed for all detected results.
[Inspect] − [Inspection] − [Shape Search II] − [Modify] − [Details] Tab Page − [Meas.
Parameter]
• You can change the output form for each measurement value to one of the following settings.
Press
[ ] − [Result type] on the right of the display.
Absolute value (default): The measured coordinates are output.
Relative value: The difference from the reference position is output as coordinates.
1 Press [Sorting method] and select the conditions by
which to sort the detected results.
You can output the results in the sort order that you se-
lected.
Selection item Setting Description
Sorting method Corr. ascending order (ascending order of correlation
value)
Sorts the results in order from the smallest correlation
to the largest.
Corr. descending order (descending order of correlation
value) (default)
Sorts the results in order from the largest correlation to
the smallest.
Pos.X ascending order (ascending order of position X) Sorts the results in order from the smallest measure-
ment X position to the largest.
Pos.X descending order (descending order of position X) Sorts the results in order from the largest measure-
ment X position to the smallest.
Pos.Y ascending order (ascending order of position Y) Sorts the results in order from the smallest measure-
ment Y position to the largest.
Pos.Y descending order (descending order of position Y) Sorts the results in order from the largest measure-
ment Y position to the smallest.
Note
You can specify the actual output conditions and count for output-
ting multiple results.
Selecting the results to output: p. 98
To Next Page
Loading...
Need help?
General
