Inspecting with the Edge Position Inspection Item
120
FQ2 User’s Manual
4-7 Inspecting with the Edge Position Inspection Item
Edge Position
This inspection item is used to inspect positions. For example, it can be used to see if a label is attached at the
correct position or if a product is set in the correct position.
Places where the color changes greatly are called edges. The positions of these edges are measured.
Setup Procedure for Edge Position
Step 1 Selecting the Inspection Item
[Inspect] − [Inspection]
1 Press an unused inspection item number and press
[Add item.].
2 Press [Edge position].
Registering inspection items: p. 93
Drag the arrow at the bottom of the menu upward to display all of the inspection items.
OK NG
Edge search
direction
Color of edge
to be found
Measurement region
An edge is detected within the region
according to set direction and color.
Sample Settings Sample Measurement
To Next Page
Loading...
Need help?
General
