Controlling Operation and Outputting Data with the Sensor's Standard Parallel Connection
240
FQ2 User’s Manual
Setting the Outputs
Using the Overall Judgement Result
When the results of the inspection items are judged, if even one individual judgement result is NG, the OR
output signal is turned ON.
Wiring
Timing Chart
The OR signal that is output is held until the next overall judgement is output.
• The overall judgement result output signal can also be turned ON when all individual judgement results are OK.
Changing the judgement output ON condition: p. 244
• You can select whether to include the judgement result of one of the expressions (0 through 31) in the overall
judgement.
Using Calculation Results without Applying Them to the Overall Judgement: p. 161
• You can adjust the timing for outputting the OR signal and the ON time after judgement processing.
Adjust the Judgement Output Timing: p. 242
Color Signal Description
The signals shown at the left are used.
Refer to the following information for signal wiring.
Black OUT0 (OR) Overall judgement (default
assignment)
2-4 Wiring: p. 42
OK
NG
OK
Inspection
item 31
If there is even one NG judgement,
the overall judgement will be NG
and the output will be turned ON.
NG (OR signal ON)
Inspection
item 1
Overall judgement
Inspection
item 0
Individual judgement results
OK
Expression
Note
OFF
ON
OFF
ON
Overall judgement
Turned ON when overall
judgement is NG.
(OR output: ON for NG)
OR signal
ON while measurements are
being processed (depends
on BUSY output conditions)
BUSY signal
TRIG signal
ON for 1 ms min.
To Next Page
Loading...
Need help?
General
