Controlling Operation and Outputting Data with the Sensor's Standard Parallel Connection
FQ2 User’s Manual
241
8
Controlling Operation and Outputting Data
with a Parallel Connection
Getting Individual Judgements and Expression Judgements
Up to three judgement results of individual inspection items (item judgement signals OR0 to OR31) and
expression judgements (expression 0 judgement to expression 31 judgement) can be assigned to terminals
OUT0 to OUT2 and output to external devices.
Wiring
Example: Signals are assigned to terminals OUT0 to OUT2 as shown below.
• OUT0: Item 2 judgement (OR2)
• OUT1: Item 5 judgement (OR5)
• OUT2: Item 14 judgement (OR14)
As described above, if terminals OUT0 to OUT2 are all assigned to individual judgement output signals, the
BUSY signal and ERROR signal assigned as the default settings will no longer be output.
The timing for updating the OR signal and the ON time after judgement processing can be adjusted.
Adjusting the judgement output timing: p. 242
Output terminal Default assignment Output signals that can be assigned
OUT0 OR (Total judgement) • Control signals: OR, BUSY, ERROR, READY, and RUN
STG (strobe trigger)
• Item judgements: OR0 (Item 0 judgement) to OR31
(Item 31 judgement)
• Expression judgements: Expression 0 judgement to
expression 31 judgement
OUT1 BUSY
OUT2 ERROR
The timing for updating the OR0 to OR31 signals and the ON time after judgement processing can be
changed.
Adjusting the judgement output timing: p. 242
Color Signal Description
The signals shown at the left are used.
Refer to the following information for signal wiring.
2-4 Wiring: p. 42
Black OUT0 (OR2) Outputs the judgement for
OR2.
Orange OUT1 (OR5) Outputs the judgement for
OR5.
Light
blue
OUT2 (OR14) Outputs the judgement for
OR14.
Note
To Next Page
Loading...
Need help?
General
