Electrical Installation
This chapter explains proper procedures for wiring the control circuit terminals, motor and power
supply.
3.1 SECTION SAFETY............................................................................................30
3.2 STANDARD CONNECTION DIAGRAM...........................................................32
3.3 MAIN CIRCUIT CONNECTION DIAGRAM.......................................................34
3.4 TERMINAL BLOCK CONFIGURATION...........................................................35
3.5 PROTECTIVE COVERS....................................................................................36
3.6 MAIN CIRCUIT WIRING....................................................................................37
3.7 CONTROL CIRCUIT WIRING...........................................................................40
3.8 I/O CONNECTIONS...........................................................................................44
3.9 MAIN FREQUENCY REFERENCE...................................................................46
3.10 BRAKING RESISTOR.......................................................................................47
3.11 INTERLOCKING WITH CONNECTED MACHINERY.......................................48
3.12 WIRING CHECKLIST........................................................................................49
3
SIEP C710606 33A OYMC AC Drive – J1000 User Manual
29
To Next Page
Loading...
Need help?
General