Omron SYSMAC CP2E-E D Series User Manual

2 Internal Memory in the CPU Unit
2-4
CP2E CPU Unit Software User’s Manual(W614)
Data that has been created using the CX-Programmer or CX-Integrator is transferred to the internal
memory in the CPU Unit as shown in the following diagram.
The CPU Unit will access the backup memory in the following process.
• The program, parameters, comments, program index or symbol table are transferred from the CX-
Programmer and CX-Integrator.
• The program is changed during online editing.
• DM backup is operated by the Auxiliary Area.
During these processes, BKUP LED will light, indicating that the CPU Unit is being backed up.
There are the following limitations during backup.
• The operation mode cannot be switched from PROGRAM mode to MONITOR/RUN mode.
• If the power supply is interrupted when the program or parameters are being transferred or backed
up, memory error may occur when the power supply is turned ON next time.
• If the power supply is interrupted when the DM area is being backed up, the reading of backed up DM
area will fail when the power supply is turned ON next time.
2-1-3 Transferring Data from a Programming Device
2-1-4 Backup
CX-Programmer
Function Block
Symbol Table
Comments and
Program Index
PLC Setup
User Program Area
FB Program Area
User Program
Function Block
Program Source
Source and Comment Areas
Symbol Table
Comments and
Program Index
IP Router Table
PLC Setup
IP Router Table
IP Address Table
CPU Unit
I/OMemory
Routing Table
IP Address Table
CX-Integrator
The CX-Programmer can be used to
set I/O memory status and write data
to I/O Memory areas.
I/O Memory Areas
Routing Table
Parameter Area
User-created Programs
User Program

Omron SYSMAC CP2E-E D Series Specifications

General

Brand	Omron
Model	SYSMAC CP2E-E D Series
Category	Computer Hardware
Language	English