5.36
BODY / STEERING / SUSPENSION
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
BALL JOINT SERVICE
Service Preparation
IMPORTANT: Do not reuse a ball joint if it has been
removed. If removed, it must be replaced. Use this
removal procedure only when replacing the ball joint.
NOTE: Ball joint tool PU-50506 wi
ll allow the upper
and lower ball joints to be replaced with the A-arm
installed on the vehicle.
The A-arm does not need to be removed to perform this
p
rocedure if ball joint tool PU-50506 is used.
1. Properly lift and support the vehicle by the frame.
2. Remove the appropriate front wheel.
3. To
service the upper ball joint:
- Remove and discard the two front brake caliper
mo
unting bolts and remove the caliper from the brake
disc (see “Brakes” chapter).
- Remove and discard the upper ball joint pinch bolt.
- If necessary, remove the lower front shock fastener
fro
m the A-arm to gain enough clearance to install ball
joint tool (PU-50506) on the upper ball joint.
4. To
service the lower ball joint:
- Remove and discard the lower ball joint pinch bolt.
- If necessary, remove the lower front shock fastener
fro
m the A-arm to gain enough clearance to install ball
joint tool (PU-50506) on the lower ball joint.
Ball Joint Removal
1. Remove the retaining ring from the ball joint.
2. Install Spacer (A) over the top of the ball joint face.
3. Place Removal Adaptor (B) over the ball joint shaft.
4. Install the Press Asm. (C) onto the A-arm to engage
the
ball joint Removal Adapter.
IMPORTANT: Be sure the Press Asm. opening is only
cont
acting the Spacer (A) and not the ball joint face.
5. Tighten the Press Asm. scr
ew and fully remove the
ball joint from the A-arm.
PU-50506
Press Asm. (C)
Spacer (A)
Installation
Removal
Adapter (D)
Adapter (B)
Ball Joint
Upper A-arm
Retaining Ring
Picture For Reference Only
To Next Page
Loading...
Need help?
General
