To Next Page

To Previous Page

10.5

ELECTRICAL

9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual

Ignition Key Switch (INT’L)

1. Disconnect the key switch harness by lifting the

connector lock and pulling on the connector. Do not

pull on the wiring.

2. Test between the 4 sets of outputs (OFF / ON LIGHTS

/ ON / START). If any of the tests fail, replace ignition

switch assembly.

• Turn the ignition key to ON LIGHTS. There should

be continuity between switch pins A, E and F; C

and D.

• Turn the ignition key to ON. There should be

continuity between pins C and D; E and F.

• Turn the ignition key to START. There should be

continuity between pins A and B; C and D; E and

AWD / 2WD Switch

1. Disconnect the AWD / 2WD switch harness by

depressing the connector locks and pulling on the

connector. Do not pull on the wiring.

2. Test between the 2 sets of outputs (AWD / 2WD). If

any of the tests fail, replace the switch assembly.

• Move the switch to AWD (ON). There should be

continuity between switch pins 2 and 3.

• Move the switch to 2WD (NONE / OFF). There

should be no continuity between any pins.

Polaris 2013 RANGER RZR S User Manual

Questions and Answers: