7.27
FINAL DRIVE
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
NOTE: Due to extremely close tolerances and
minimal wear, the bearings must be inspected
visually, and by feel. While rotating bearings by
hand, inspect for rough spots, discoloration, or
corrosion. The bearings should turn smoothly and
quietly, with no detectable up and down movement
and minimal movement sideways between inner and
outer race.
Bearing Replacement
Bearing Removal
1. Remove outer snap ring.
2. From the back side of the bearing carrier, tap on the
o
uter bearing race with a drift punch in the reliefs as
shown.
3. Drive bearing out evenly by tapping on outer race
o
nly. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
4. Inspect the bearing carrier housing for scratches,
wea
r or damage. Replace rear bearing carrier if
damaged.
Bearing Installation
5. Thoroughly clean the rear bearing carrier housing and
th
e outer race on the new bearing. Be sure that all oil
residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
7. Apply Loct
ite
®
603
™
retaining compound to the outer
circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
housing.
NOTE: Use care to not allow any of the Loctite
®
compound to get in the bearing.
8. Wipe the housing clean of any excess compound and
i
nstall the snap ring.
Bearing Carrier Bushing Replacement
Check bearing carrier bushings and pivot tubes for
excessive wear or damage. If replacement is required,
slide pivot tubes out and remove bushings with a drift
punch. Install new bushings by pressing them into the
bearing carrier.
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
Apply
Loctite® 603™
Bearing
Snap Ring
Pivot Tube
Pivot
Control Arm
Bushing
Control Arm
Bushing
Bushing
Pivot Tube
To Next Page
Loading...
Need help?
General
