To Next Page

To Previous Page

7.24

FINAL DRIVE

9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual

11. Install a new O-ring on the cover plate assembly.

NOTE: Be sure the square O-ring is placed flat on

he cover surface. If the O-ring is twisted fluid

leakage may occur.

12. Carefully install the LH outp

ut hub assembly into the

cover plate. Take care not to damage the new cover

plate seal while installing the output hub.

13. Install the output cover assembly onto the gearcase

using. Install the (7) cover plate screws and torque

to specification.

Gearcase Installation

1. Install the gearcase back into the vehicle through the

LH wheel well area, between the upper and lower A-

arms.

2. Install the propshaft onto the front gearcase input

aft. Use a NEW roll pin in the front propshaft.

3. Install the (4) bolts that secure the front gearcase to

e frame and torque to 30 ft-lbs (41 Nm).

4. Install the vent line.

= T

Cover Plate Screws:

7-11 ft-lbs (10-15 Nm)

LH Hub

Torque Screws

= T

Front Gearcase Mounting Bolts:

30 ft-lbs (41 Nm)

30 ft-lbs

Install

Vent Line

Connect

Harness

(41 Nm)

Gearcase image is

for reference only.

PRELIMINARY VERSION

Polaris 2013 RANGER RZR S User Manual

Questions and Answers: