7.33
FINAL DRIVE
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Inner Plunging Joint / Boot Replacement
1. Use a side cutters to cut and discard the boot clamps.
2. Remove the large end of the boot from the plunging
join
t and slide the boot down the shaft.
3. Clean the grease from the face of the joint and place
the
drive shaft in a soft-jawed vise.
4. Using a soft-faced hammer, or brass
drift, strike inner
race of the joint to drive the joint off the drive shaft. Be
sure to tap evenly around the joint to avoid binding.
IMPORTANT: Tap on inner race only!
5. Make sure circlip is on the shaft and not left in the joint.
6. Remove the boot from the shaft.
IMPORTANT: If the grease in the joint is obviously
cont
aminated with water and/or dirt, the joint should
be replaced.
7. Thoroughly clean the joint with an appropriate solvent
a
nd dry the joint to prevent any residual solvent from
being left in the joint upon reassembly.
8. Visually inspect joint for damage. Replace if needed.
9. Clean the splines on the end of the shaft and apply a
l
ight coat of grease prior to reassembly.
10. Slide the small boot clamp and boot (small end first)
o
nto the drive shaft and position the boot in its groove
machined in the shaft.
Complete disassembly of the plunging joint is
NOT recommended. The internal components
are precision fit and develop their own
characteristic wear patterns. Intermixing the
internal components could result in looseness,
binding, and/or premature failure of the joint.
To Next Page
Loading...
Need help?
General
