To Next Page

To Previous Page

10.11

ELECTRICAL

9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual

ALL WHEEL DRIVE COIL

Operation Overview

• When the AWD switch is “ON”, 12 VDC power is

present at the hub coil.

• If the criteria is met, the Engine Controller provides

a ground path (brown/white wire). When this

occurs the AWD icon should display in the

instrument cluster.

• The AWD system must be grounded to operate.

Diagnosing System Failures

• Verify the AWD switch is functional and that a

minimum of 11 volts is present at the hub coil.

• Verify the AWD hub coil is functional. Test the

AWD hub coil using an ohm meter. See

specifications below:

• Verify the wiring harness, wiring, connectors,

connector pins and grounds are undamaged,

clean and connect properly.

• Verify continuity of wire connections with a known

good volt/ohm meter.

IMPORTANT: Verify all wires and wiring connections

have been tested properly with a known good volt/

ohm meter before suspecting a component failure.

80% of all electrical issues are caused by bad/failed

connections and grounds.

AWD Hub Coil Resistance:

 ± 5%

Test Resistance Test Resistance

Readings should be: Readings should be:

GY to BN/WH: ~ 24 OhmsGY to BN/WH: ~ 24 Ohms

GY to Ground: No ConnectionGY to Ground: No Connection

Polaris 2013 RANGER RZR S User Manual

Questions and Answers: