Polaris 2013 RANGER RZR S User Manual

7.29
FINAL DRIVE
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Torque wheel hub nut to 80 ft-lbs (108 Nm) and install
a NEW cotter pin. Tighten nut slightly if necessary to
align cotter pin holes.
7. Install wheel and (4) wheel nuts. Torque wheel nuts
to specification.
8. Rotate wheel and check for smooth operation. Bend
b
oth ends of cotter pin around end of spindle in
different directions.
REAR DRIVE SHAFT
Drive Shaft Removal
1. Elevate rear of vehicle and safely support machine
under the frame area.
2. Remove the (4) wheel nuts and remove rear wheel.
3. Remove the cotter pin and loosen the rear wheel hub
ca
stle nut. Remove the nut, and (2) cone washers
from the rear wheel hub assembly.
4. Remove the two brake caliper mounting bolts. 
CAUTION: Do no
t hang the caliper by the brake line.
Use wire to hang caliper to prevent damage to the
brake line.
5. Remove the rear wheel hub assembly.
= T
Wheel Hub Castle Nut:
80 ft-lbs (108 Nm)
= T
Wheel Nuts:
Steel Wheels: 27 ft-lbs (37 Nm)
Aluminum Wheels: 30 ft-lbs + 90° (1/4 turn)
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
80 ft-lbs
(108 Nm)
NEW Cotter Pin
Castle Nut
Cotter Pin
Cone
Washers
Remove
PRELIMINARY VERSION

Polaris 2013 RANGER RZR S Specifications

General

Brand	Polaris
Model	2013 RANGER RZR S
Category	Offroad Vehicle
Language	English