3.40
ENGINE / COOLING
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Inspect gear teeth on starter drive. Replace starter
drive if gear teeth are cracked, worn, or broken.
7. Inspect the bendix bushing (C) in the mag cover for
wea
r. Replace as needed.
Flywheel / Stator Removal / Inspection
1. Remove stator cover bolts and remove stator cover.
2. Remove flywheel nut and washer.
3. Install Flywheel Puller (
PN 2871043) and remove
flywheel (A).
4. Use caution when removing the wire holddown (B)
and
the stator assembly (D). Do not tap or bump the
gear /stator housing cover or the stator. This could
cause the seal around the gear/stator housing cover
and the crankcase to break, causing a leak.
5. Remove the bendix (E) if necessary.
Engine Crankcase Disassembly / Inspection
1. Remove stator cover (A) and water pump cover (B).
Do not thread the puller bolts into the flywheel
more than 1/4" or stator coils may be damaged.
To Next Page
Loading...
Need help?
General
