3.41
ENGINE / COOLING
3
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
2. Remove the nut (C), washer (D) and water pump
impeller (E). Remove part of the water pump seal
behind the impeller.
3. Remove flywheel nut and washer.
4. Install Flywheel Puller (
PN 2871043) and remove
flywheel (F).
5. Remove the starter bendix (G), wire holddown plate
(
H), and the woodruff key (I) from the crankshaft. The
stator does not have to be removed at this point.
6. Remove the gear/stator housing bolts and remove the
g
ear/stator housing cover (J) and gasket from the
crankcase. Be sure to catch the excess oil from the
crankcase.
7. Note the position of the gears in the photo.
Do not thread the puller bolts into the flywheel
more than 1/4" or stator coils may be damaged.
Counterbalance Gear
Camshaft Gear
Crank Gear
To Next Page
Loading...
Need help?
General
