Polaris 2013 RANGER RZR S User Manual

7.22
FINAL DRIVE
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
14. Inspect the roll cage assembly (B) sliding surfaces
and H-springs. The sliding surfaces must be clean
and free of nicks, burrs or scratches. If damaged,
replace the roll cage assembly.
15. Inspect both output hub assemblies. Inspect the
b
earings and replace if needed.
16. Clean and inspect all re
maining front gearcase
components. Check each for excessive wear or
damage.
Gearcase Assembly
1. As mentioned during gearcase disassembly section,
replace all O-rings, seals and worn components.
2. Install pinion shaft assembly and install internal snap
ring
.
NOTE: If bearing replacement was required, press
new
bearing onto the pinion shaft and install a new
external snap ring.
3. Install a new pinion shaft seal into the pinion gear
hou
sing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.
4. Install the RH output hub into the gearcase housing.
5. Carefully install the rollers into the roll
cage assembly
while installing the assembly into the clutch housing.
B
H-Spring
Bearing
Spacer
Roller
Thrust
Bearing
Surface
Press in oil seal
just past chamfer
RH Output Hub
PRELIMINARY VERSION

Polaris 2013 RANGER RZR S Specifications

General

Brand	Polaris
Model	2013 RANGER RZR S
Category	Offroad Vehicle
Language	English