7.45
FINAL DRIVE
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
5. Disconnect the differential solenoid 2-wire harness.
6. Remove the fasteners and bracket that secure the
r
ear gearcase to the transmission.
7. Remove the (4) fasteners and remove the rear mount
fro
m the rear gearcase.
8. Pull the rear gearcase towards the rear of the vehicle
to disen
gage it from the transmission.
NOTE: If the splined coupler doesn’t slide off the
input
shaft on the rear gearcase, use a screwdriver
to hold back the coupler while pulling the rear
gearcase back further to disengage it.
9. Remove the vent line and lift the r
ear gearcase
upward and on its side to remove it from the vehicle.
Gearcase Disassembly
IMPORTANT: The pinion gear assembly is NOT
intended to be disassembled from the case, as it
requires special OEM tooling in order to properly
reassemble. If there is any damage to the pinion gear,
bearings or case, the entire gearcase assembly must
be replaced. Pinion and ring gear shimming
information is NOT provided in this Service Manual
due to OEM manufacturing requirements.
1. Remove the remaining cover bolts from the rear
gearcase.
2. Remove the cover fr
om the gearcase.
3. Remove the differential assembly from the housing.
Note the number or
thickness of shims for
reassembly purposes.
To Next Page
Loading...
Need help?
General
