7.31
FINAL DRIVE
7
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
5. Make sure circlip is on the shaft and not left in the joint.
6. Remove the CV boot from the shaft.
IMPORTANT: If the grease in
the joint is obviously
contaminated with water and/or dirt, the joint should
be replaced.
7. Thoroughly clean the joint with an appropriate solvent
a
nd dry the joint to prevent any residual solvent from
being left in the joint upon reassembly.
8. Visually inspect the joint by tiltin
g the inner race to one
side to expose each ball. Severe pitting, galling, play
between the ball and its cage window, any cracking
or damage to the cage, pitting or galling or chips in
raceways call for joint replacement.
NOTE: Shiny areas in ball tracks and on the cage
sphe
res are normal. Do not replace CV joints
because parts have polished surfaces. Replace CV
joint only if components are cracked, broken, worn
or otherwise unserviceable.
9. Clean the splines on the end of the shaft and apply a
l
ight coat of grease prior to reassembly.
10. Slide the small boot clamp and boot (small end first)
o
nto the drive shaft and position the boot in it’s groove
machined in the shaft.
11. Install a NEW circlip on the end of the shaft.
12. Grease the joint with the s
pecial CV joint grease
provided in the boot replacement kit. Fill the cavity
behind the balls and the splined hole in the joint’s inner
race. Pack the ball tracks and outer face flush with
grease. Place any remaining grease into the boot.
NOTE: It is very important to use the correct type
and qu
antity of grease by using all the grease
included with the boot kit. DO NOT use a substitute
grease and DO NOT overfill or under fill the CV joint.
Complete disassembly of the CV joint is NOT
recommended. The internal components are
precision fit and develop their own characteristic
wear patterns. Intermixing the internal
components could result in looseness, binding,
and/or premature failure of the joint.
The grease provided in the replacement kit is
specially formulated for wear resistance and
durability. DO NOT use substitutes
or mix with other lubricants.
Boot Replacement Grease Requirement:
Outer CV Joint Capacity:
RZR - 80g
RZR S / RZR 4 - 90g
Grease Only Service Kit: PN 1350047 (50g)
To Next Page
Loading...
Need help?
General
