Polaris 2013 RANGER RZR S User Manual

7.36
FINAL DRIVE
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
4. Lift bearing carrier into place and install the bolt
attaching the bearing carrier to the upper A-arm.
Torque fastener to specification.
5. Apply grease to drive shaft axle splines.
6. Install rear wheel hub assembly, cone washers, and
h
and tighten the castle nut. Install washers with
domed side out.
7. Install brake caliper mounting bolts and torque to
spec
ification.
8. Torque wheel hub nut to specification and install a
NEW cotter
pin. Tighten nut slightly if necessary to
align cotter pin holes.
9. Install wheel and (4) wheel nuts. Torque wheel nuts
to specification.
= T
Upper Rear Bearing Carrier Bolt:
RZR: 33 ft-lbs (45 Nm)
RZR S / RZR 4: 40 ft-lbs (54 Nm)
Out
Cone Washers
Wheel
Hub
18 ft-lbs
24 (Nm)
= T
Rear Caliper Mounting Bolts:
18 ft-lbs (24 Nm)
CAUTION
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
= T
Wheel Hub Castle Nut:
80 ft-lbs (108 Nm)
= T
Wheel Nuts:
Steel Wheels: 27 ft-lbs (37 Nm)
Aluminum Wheels: 30 ft-lbs + 90° (1/4 turn)
80 ft-lbs
(108 Nm)
NEW Cotter Pin
PRELIMINARY VERSION

Polaris 2013 RANGER RZR S Specifications

General

Brand	Polaris
Model	2013 RANGER RZR S
Category	Offroad Vehicle
Language	English