Scalar i6000 Installation Guide 93
Applying Power
The instructions in this chapter tell you how to apply power to a library. Before applying power, you should
perform a voltage check. The information in this chapter includes:
• Supported AC Power Cables
on page 93
• Powering on the Library
on page 94
Supported AC Power Cables
Each library is configured with a single AC power source, but redundant power is an option. If redundant
power is chosen, the control module and all expansion modules that contain tape drives require two
independent AC power sources.
The power cable length for each of these inputs is 14 feet (4.26 m). See Table 2
on page 93.
Table 2 Electrical Specifications for Control and Expansion Modules
You must install your library with two independent power sources to
have redundant power. You will NOT have redundant power if you use
only one AC power source.
Location
Voltage (Single
Phase, 50 - 60 Hz)
Required Protective
Service
Delivered Power
Connector
AMPs
North America 110 30 NEMA L5 - 30 30
North America 208 15 NEMA L6 - 15 15
International 240 16 IEC60309 2P+E 20
a
or 16
b
a. 20 amps in North America
b. 16 amps international
To Next Page
Loading...
Need help?
General