Scalar i6000 Installation Guide 169
Setting Date and Time
1 Click Setup→ Date and Time.
The Date and Time dialog box appears.
2 In the NTP section:
• If you choose to enable NTP, click Enable.
The Date and Time sections of the dialog box are grayed out.
• Type valid IP addresses for the Primary Server and optionally the Secondary Server.
• If the DNS Server has not been configured in the LMC, type valid numeric IP addresses
that are accessible from the library (example 111.11.11.111). You have the option of using
one or two IP addresses. Go to step 5.
• If the DNS Server has been configured through the LMC (Setup→ DNS Configuration),
type the valid alpha/numeric IP Addresses that are accessible from the library. You have
the option of using one or two IP addresses. Go to step 7.
• If NTP is enabled and you no longer want to use this setting, click Disable.
If you choose to disable NTP, you must manually set the date and time. Go to the next step.
3 Use the Date drop-down lists to select the month, date, and year.
4 Use the Time drop-down lists to select the hour, minute, and whether the time is A.M. or P.M.
5 Use the Time Zone drop-down list to select the appropriate time zone.
To Next Page
Loading...
Need help?
General