Ricoh D127 User Manual

Dedicated Transmission Parameters
D127/D128 5-84 SM Appendix
5.4.2 PARAMETERS
Fax Parameters
The initial settings of the following fax parameters are all FF(H) - all the parameters are disabled.
Switch 00
FUNCTION AND COMMENTS
ITU-T T1 time (for PSTN G3 mode)
If the connection time to a particular terminal is longer than the NCU parameter setting,
adjust this byte. The T1 time is the value stored in this byte (in hex code), multiplied by 1
second.
Range:
0 to 120 s (00h to 78h)
FFh - The local NCU parameter factory setting is used.
Do not program a value between 79h and FEh.
Switch 01
No FUNCTION COMMENTS
0-4
Tx level If communication with a particular
remote terminal often contains
errors, the signal level may be
inappropriate. Adjust the Tx level
for communications with that
terminal until the results are
better.
If the setting is "Disabled", the
NCU parameter 01 setting is
used.
 Do not use settings other
than listed on the left.
Bit4 Bit3 Bit2 Bit1 Bit0
0 0 0 0 0 0
0 1 0 0 0 –8
0 1 1 1 1 –15
1 1 1 1 1 Disabled

Ricoh D127 Specifications

General

Brand	Ricoh
Model	D127
Category	All in One Printer
Language	English