Activating the Security Applications
1. Make sure that the following settings are not at their factory default values:
 Supervisor login password
 Administrator login name
 Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must be
changed before you do the installation procedure.
2. Make sure that "Admin. Authentication" is ON.
[System Settings] – [Administrator Tools] – [Administrator Authentication Management] -
[Admin. Authentication]
If this setting is OFF, tell the customer this setting must be ON before you do the installation
procedure.
3. Make sure that "Administrator Tools" is enabled (selected).
[System Settings] – [Administrator Tools] – [Administrator Authentication Management] -
[Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled
(selected) before you do the installation procedure.
4. Refer to the Security Reference for details about activating the security applications (HDD
Encryption Unit and DataOverwriteSecurity).
HDD Encryption Recovery from a Device Problem
The flowchart below shows the recovery possibility of the HDD encryption if one of devices related
with the HDD encryption is defective.
To Next Page
Loading...
Need help?
General
