CUTTER UNIT REPLACEMENT
SM 7-7 B435/B436
Roll Feed Unit
B435/B436
3. REPLACEMENT AND ADJUSTMENT
3.1 CUTTER UNIT REPLACEMENT
1. Remove the roll feed unit’s front cover [A] (2 screws and 4 hooks) and left inner
cover [B] (2 screws).
2. Remove the left tray lock lever [C] (1 screw and 1 spring) and tray stopper [D]
(2 shoulder screws and 1 spring).
3. Remove the two screws [E] and disconnect the three connectors [F].
NOTE: When removing and/or reinstalling the connectors, take care not to
damage the harnesses. Make sure that you do not pinch the harnesses
when reinserting the cutter unit.
4. Slide the cutter unit [G] out as shown.
B436R103.WMF
B436R102.WMF
[C]
[D]
[A]
[B]
[G]
[E]
[F]
[F]
To Next Page
Loading...
Need help?
General