ROLL FEED LEADING EDGE SENSOR REPLACEMENT
B435/B436 7-8 SM
3.2 ROLL FEED LEADING EDGE SENSOR
REPLACEMENT
1. Pull out the roll feed unit.
2. Remove the sensor casing [A] (2 screws).
3. Replace the leading edge sensor [B] (1 screw and 1 connector).
NOTE: When reinstalling the sensor casing, be sure to align the sensor casing’s
pins [C] with the holes [D] in the sensor bracket.
B436R107.WMF
[A]
[C]
[B]
[D]
To Next Page
Loading...
Need help?
General