8.5ENERGY SAVER FUNCTION
When the copier is not in use, the energy saver function reduces the power
consumption by decreasing the fusing temperature.
When the Clear Modes/Stand-by key is hold down for over 2 seconds, the copier
goes into the energy saver mode. A message is displayed on copy counter and
all the other indicators turn off.
The fusing temperature is decreased by 15°C from one of the normal mode
settings for copying. The energy saving ratio is approximately 14%. The waiting
time until the copier returns to the ready condition is approximately 60 seconds.
NOTE:The above energy saving ratio is a standard value measured in
laboratory tests under controlled conditions. The actual ratio will vary
depending on environmental conditions, copy modes, power supply
conditions and measurement instruments.
Press the Clear Mode/Standby key. The copier is returned to the ready condition
after a warm-up time.
When the auto energy saver mode (SP #10) is selected, the copier automatically
goes to the energy saver mode at the auto reset time selected by SP #9.
SM 2-34 A163
To Next Page
Loading...
Need help?
General