Roland EGX-350 User Manual

102
Chapter 7 Troubleshooting
7-2 Troubleshooting (Operation)
The USB cable came loose during engraving.
If the machine succeeded in receiving all the engraving data,
the engraving is carried out to the end of the operation. If the
machine did not receive all the engraving data, engraving is
carried out for the portion received, and then the cutter rises
and stops at a location away from the workpiece. The message
[Command Not Recognized] may be displayed at this time. If
this happens, switch o the power and redo the operation from
the beginning
 P. 40, “Starting and Quitting,” p. 104, “ Responding to an Error Mes-
sage”

Roland EGX-350 Specifications

General

Drive System	Stepper motor
Interface	USB
Engraving Area	350 x 300 mm
Engraving Area (mm)	300 x 210 mm
Software Resolution (mm)	0.01 mm/step
Spindle Speed	7, 000 rpm
Power Supply	AC 100 - 240 V, 50/60 Hz
Acoustic Noise	65 dB (A) or less (when not cutting)
Operating Temperature	5 - 40 °C
Operating Humidity	35 to 80% (no condensation)
External Dimensions (mm)	680 x 580 x 430