Roland EGX-350 User Manual

Chapter 2 Installation and Setup
26
2-1 Checking the Included Items
The following items are included with the machine. Make sure they are all present and accounted for.
Power cord Depth regulator nose
(nose unit)
Noes-unit retainer Wrench
Character cutter
(diameter 3.175 mm,
with cutter holder)
Flat cutter
(diameter 3.175 mm,
with cutter holder)
Spare tool retaining screw Hexagonal wrench
Collet
(diameter 3.175 mm)
Collet
(diameter 4.36 mm)*1,*2
Hexagonal screwdriver Handy panel
Adhesive sheet Vacuum-adapter set User’s Manual Software guide
(Roland Software Package)
(Roland Engrave Studio)
Roland Software Package
CD-ROM
Roland Engrave Studio
CD-ROM
*1: This is for diameter-4.36 mm character or at cutters. It cannot be used with diamond scrapers or end mills.
*2: Never use a diameter-4.36 mm cutter at a spindle speed of 15,000 rpm or higher. There is danger of damage to the
spindle unit due to vibration.
Retaining
screw
Spring

Roland EGX-350 Specifications

General

Drive System	Stepper motor
Interface	USB
Engraving Area	350 x 300 mm
Engraving Area (mm)	300 x 210 mm
Software Resolution (mm)	0.01 mm/step
Spindle Speed	7, 000 rpm
Power Supply	AC 100 - 240 V, 50/60 Hz
Acoustic Noise	65 dB (A) or less (when not cutting)
Operating Temperature	5 - 40 °C
Operating Humidity	35 to 80% (no condensation)
External Dimensions (mm)	680 x 580 x 430