51
Chapter 4
Engraving
4-1 Flow of Engraving Operations .......................................................................52
4-2 Mounting a Workpiece ...................................................................................54
4-3 Selection of the Cutter (Usage Examples).....................................................55
4-4 Cutter Installation Method 1 (With Nose Unit) ...............................................56
Installing a Character Cutter (With Nose Unit) .................................................... 56
Important Notes When Using the Nose Unit........................................................ 61
4-5 Cutter Installation Method 2 (No Nose Unit) ..................................................62
Installing a Character Cutter (With No Nose Unit) ............................................... 62
4-6 Cutter Installation Method 3 (Diamond Scraper) ...........................................67
Installing a Diamond Scraper .............................................................................. 67
4-7 Cutter Installation Method 4 (End mill)...........................................................71
Installing a End Mill .............................................................................................. 71
4-8 Setting the XY Origin Point ............................................................................75
Setting the XY Origin Point (Home Position) ....................................................... 75
4-9 Performing Engraving ....................................................................................76
Performing Engraving .......................................................................................... 76
Adjusting the Cutter Feed Rate During Engraving (Override) ............................. 77
Executing Repeated Cutting ................................................................................ 78
To Next Page
Loading...
Need help?
General
