Roland EGX-350 User Manual

Chapter 4 Engraving
54
4-2 Mounting a Workpiece
WARNING
Never inadvertently touch the computer or handy panel while performing this
task.
Unintended operation of the machine may result in injury.
CAUTION
Caution: cutting tool.
The cutting tool is sharp. To avoid injury, exercise caution.
When Using an Adhesive Sheet
Afx the adhesive sheet to the work-
piece table, then place the workpiece
on the adhesive sheet and press
down on it from above to secure it in
place.
On this machine, you can also use optionally available items to secure the workpiece in place: a center vise (ZV-23C) or a vacuum
table (ZV-23A). For detailed information about these optional items, contact your authorized Roland DG Corp. dealer.
Adhensive sheet
Workpiece Workpiece table

Roland EGX-350 Specifications

General

Drive System	Stepper motor
Interface	USB
Engraving Area	350 x 300 mm
Engraving Area (mm)	300 x 210 mm
Software Resolution (mm)	0.01 mm/step
Spindle Speed	7, 000 rpm
Power Supply	AC 100 - 240 V, 50/60 Hz
Acoustic Noise	65 dB (A) or less (when not cutting)
Operating Temperature	5 - 40 °C
Operating Humidity	35 to 80% (no condensation)
External Dimensions (mm)	680 x 580 x 430