2
Wired Connection
Connect a local area network (LAN) port of the access point to the network port of the PC,
and set the IP address of the PC. See Configuring the IP Address of the Management
Client.
Wireless Connection
On a mobile phone or laptop, search for wireless network @Ruijie-SXXXX (XXXX is the last
four digits of the MAC address of each device). In this mode, you do not need to set the
IP address of the management Client, and you can skip the operation in Configuring the
IP Address of the Management Client.
1.3.2 Configuring the IP Address of the Management Client
Configure an IP address for the management client in the same network segment as the
default IP address of the device (The default device IP address is 10.44.77.254, and the
subnet mask is 255.255.255.0.) so that the management client can access the device. For
example, set the IP address of the management client to 10.44.77.100.
Caution
Make sure that the client can access the Eweb system as long as it can ping the
access point.
The IP address of the management client cannot be set to 10.44.77.253, because this
IP address is reserved by the device. If the management client uses this IP address, it
cannot access the device.
1.3.3 Logging in to the Web Page
(1) Enter the IP address (10.44.77.254 by default) of the access point in the address bar of
the browser to open the login page.
Note
If the static IP address of the device is changed, or the device obtains a new dynamic IP
address, the new IP address can be used to access the web management system of the
device as long as the management client and the device are in the same network
segment of a LAN.
To Next Page
Loading...
Need help?
General
