Web-based Configuration Guide Network Settings
138
access the Internet through the current LAN should be set to this IP
address.
Subnet mask of the IP address of the VLAN interface.
MAC address of the VLAN interface.
Enable the DHCP server function. After it is enabled, devices on the LAN
can automatically obtain IP addresses. After the DHCP service is enabled,
you need to configure the start IP address to be assigned, number of IP
addresses to be assigned, and address lease term for the DHCP server,
and other DHCP server options. For details, see Configuring DHCP Server.
Caution
VLAN configuration is associated with the configuration of the uplink device. Therefore,
refer to the configuration of the uplink device when configuring a VLAN.
4.7 Configuring Port VLAN
Caution
The port VLAN can be configured only when the device works in AP mode.
For RG-RAP2260(G), RG-RAP2260(E), RG-RAP6260(G), RG-RAP6262(G), RG-RAP2260(H), RG-
RAP6260(H), RG-RAP6260(H)-D, RG-RAP2266, RG-RAP2260, RG-RAP1261, RG-RAP1260 and
RG-RAP6262 models: In Local Device mode, choose Network > LAN
For other RAP models: Choose ( WLAN > APs > Manage >) Network > LAN
(1) On the LAN Settings tab page, turn on Port VLAN, and click OK in the confirmation
dialog box.
To Next Page
Loading...
Need help?
General
