256 •
Sam4POS 6600/4800II Program Manual v2.1
EFT Operation
EFT Operation Menu
SAM4POS supports credit card processing with Datacap integrated payment appliance and supports
the EMV integration protocol. (There will be no Non-EMV integration.) Credit Card (EFT)
maintenance operations can be performed at the SAM4POS terminal from the EFT Operation menu.
In the Pre-EMV environment Datacap stored some information in the Tran that allowed the registers
to run some reports, such as the local transaction report.
In the EMV environment Datacap no longer stores information in the Tran so there are no reports
available.
On the SAM4POS we are storing some information on the approvals at the register. This is required
to be able to perform “By Record” transactions. The “Clear EMV File” in the Datatran_Operation
menu should be performed daily to clear this data.
Currently, if a Local Transaction Report is run we print the information from the approvals. However,
this data should only be used for troubleshooting and should not be relied upon as accurate.
For example, if you perform a sale for $1.00 and then perform a Void by Record Number of the same
transaction, you will have two transactions. The register is only printing the information from the
approvals.
Refer to the “Datatran_Operation Definitions” on page 269 for details about these options.
1. From the main PROGRAM MODE menu, select DEVICES, then choose EFT OPERATION, from
the devices menu selections.
To Next Page
Loading...
Need help?
General
